What Circuits Typically Activate Side and Rear Camera Views of Furrion Vision S Camera System

Published 03/04/2020

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ 3 Cameras - 5" Screen

(736)

$810.36

Putco Metal LED Bulbs - 194 - 360 Degree - 1 Diode - Amber - Qty 2

$50.57

Question:

I have a 2018 airstream and my side marker lights are l.e.d. Is their version that has led lights and/or tear design.

asked by: Tony B

Expert Reply:

The trigger circuit for all of the cameras is typically the running light circuit of your trailer wiring on the Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras # FCE48TASL-05. So when you back up if you turn on the running lights, you'll have ability to select any of the rear views. You can setup the trigger circuit for the center/rear camera as the reverse light circuit if you wanted to though and it would be what shows when the vehicle is in reverse.

The motion detection features also allow you to have the side cameras shown when motion is detected like you mentioned.

expert reply by: Jameson C

Tony B.

3/4/2020

I have a 2018 airstream and my side marker lights are l.e.d. Is their version that has led lights and/or tear design.

Jameson C.

3/4/2020

The side cameras of the kit aren't LED (they could be replaced with LED bulbs if desired) but the assemblies only draw .5 of an amp so they draw lower similar to LEDs. What this means is that your current wiring would work great with these still. The bulb type of this is a 194 so for an LED you'd just want the # P340194A-360.