How to Manually Retract Lippert Ground Control Jacks After Replacing Sensor
Updated 02/17/2020 | Published 02/15/2020
Question:
I changed the sensor how do I clear the code how do I manually raise back jacks?
asked by: Jeremy
Expert Reply:
Once the sensor was changed in the Lippert Ground Control 3.0 part # LC675817 then the error code should have cleared itself. I contacted Lippert and they said to make sure the wiring harness from the rear sensor has continuity.
If the wiring harness is good and the rear sensor is installed properly, you can try to manually retract the jacks to clear the code. I have attached a snip from the instructions that shows how to manually retract the jacks.
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How Much Room on RV Frame Does Lippert Ground Control Middle and Rear Jacks Take Up
- Q&A: Will The Lippert Ground Control 3.0 Leveling System Stabilize A Trailer Better Than Scissor Jacks
- Q&A: Correct Replacement Legs for Lippert Ground Control 3.0 Leveling System - 6 Point
- Q&A: Middle Jack Isn't Working on a Lippert 3.0 LC675817
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Which Reese Goose Box Fits in Place of Lippert 1116 Pin Box
- Q&A: Dimensions of Reese RP94716-61301 Goose Box 5th Wheel to Goosneck Hitch Adapter
- Q&A: Recommended Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box for an 1116 Bolt Pattern
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure Your Trailer Wheel Bolt Pattern