Replacement Load Stop Hardware Kit for Yakima HD Bar, JetStream, FlushBar, and RailBar Crossbars
Published 01/27/2020
Products Featured in This Question
Question:
Im looking for a hardware kit for yakima load stops mounted to a overhaul rack system. Yakima says its part # 8880146. The hardware kit has replacement knobs other misc parts. I just need the knobs that apparently are not available individually.
asked by: Robert R
Expert Reply:
The part 8880146 that you referenced is that same as the Replacement Rubber Pads # 8880146, but since you mentioned load stops and hardware I believe you are looking for the Load Stop Kit # Y01161. This kit comes with 4 load stops and everything needed to install them including the adjustment knobs, I checked with Yakima and these knobs aren't available individually like you said, so if you need to get 4 of them then this is the kit you need, which will also give you some extra hardware to keep handy if you need it in the future.
Product Page this Question was Asked From
Replacement Rubber Pads for Yakima Railgrab Claws
- Accessories and Parts
- Roof Rack
- Tower Parts
- Pads
- Yakima
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will the Draw-Tite Max-Frame Trailer Hitch fit a 2024 Buick Encore GX Preferred
- Q&A: Replacement Rubber Vinyl Pads For Yakima Q Towers And Q Clips
- Q&A: Where Do the Vinyl Pads Go for a Yakima Roof Rack and Q-Clips
- Q&A: Curt vs. Draw-Tite Trailer Hitch Receivers For 2025 Chevy Trailblazer
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Replacement Pads For Yakima RailGrab Towers
- Q&A: How to Determine Which Yakima Railgrab Claw is Needed to Fit Vehicle
- Q&A: Are There Rubber Pad Replacements for Yakima Railgrab Claws
- Article: Rooftop Cargo Carriers
- Article: How to Install a Roof Rack
- Article: Hitch Mounted Cargo Carrier Information
- Article: How Much Does a Boat and Trailer Weigh?