How The Switch Is Wired On Lippert High Speed Electric Stabilizer Jack

Updated 01/27/2020 | Published 01/25/2020

Products Featured in This Question

Replacement Electric Jack Waterproof Switch with Harness for Lippert High Speed Stabilizer Jacks

(145)

$81.36

Question:

I have a 2014 Sanibel 40 foot fifth wheel with Lippert stabilizer jacks. I believe the original switch was a 3 blade rocker it went bad and was replaced with a 4 blade which one is correct?

asked by: Steve

Helpful Expert Reply:

Since trailer manufacturers do not make information readily available to the public about which model stabilizer is on the trailer I cannot speak for the previous switch set up on your Sanibel. However, the Lippert Components High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit part # LC298707 is designed with a rocker switch with 4 wires so if your current setup is a Lippert Stabilizer Jack the 4 wires are correct. I have attached a diagram that shows how the switch is wired.

If you need to replace the switch you can do so with Replacement Electric Jack Switch with Harness for Lippert Components High Speed Stabilizer Jacks part # LC387874.

expert reply by: Heather A