Will T-Strap Hinge for Trailer Door Work on 70 lb Doors and What Material is Pin Made of
Updated 01/21/2020 | Published 01/20/2020
Question:
I have doors that are made of 4 inch rigid foam core with thin T1-11 bonded to both sides and a pine frame around the edge. They weigh about 70 pounds each. Will your PLR3416-PS work? What material is the pin made of? Thanks.
asked by: Bo
Expert Reply:
Yes, the T-Strap Hinge for Side and Rear Trailer Doors - 16" Long # PLR3416-PS will absolutely work for your doors that are made about 70 lbs each. I confirmed with the manufacturer that the pin is made of steel and is 1/2 inch diameter.
I have added a link to a video review of this part for you to check out as well.
Product Page this Question was Asked From
T-Strap Hinge for Enclosed Trailers - 16" Long - 180 Degree Rotation - Polished Stainless Steel
- Trailer Door Hinges
- Strap Hinge
- Non-Removable Pin
- Stainless Steel
- 16 Inch Long
- Reverse Bracket
- 2 Inch Wide
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Strap Hinge to Replace Continuous Hinge on Enclosed Trailer Door
- Q&A: Can the Curt Friction Sway Control 17200 be Mounted on Driver Side
- Q&A: Plug and Play Brake Controller Installation for 2020 Ford Ranger with Factory 7-Way
- Q&A: Hinge for Butterfly Gate That Allows 270 Degree Swing
- Q&A: Why Doesn't Polar Hinge # PLR3408-PS Have a Weight Capacity
- Q&A: Determining Correct Replacement Door Hinge For 2000 Sooner Royale Horse Trailer
- Q&A: Replacement Hardware For B&W Companion Hitch
- Article: No Missteps Here: Best Camper and RV Steps (2022)