Replacement Cutting Edge Half and Center Edges for Fisher XV2 8-1/2 Foot Snow Plow
Published 12/11/2019
Products Featured in This Question
Question:
will this fit 8-1/2 foot XV2 fisher if so, can you send p/n for both sides and the middle as well
asked by: Ken B
0
Expert Reply:
Yes, the Replacement Cutting Edge Half # 3371311203 (OEM p# 44997) is the correct replacement for your 8-1/2 foot Fisher XV2. This can be used on either side, so for both sides you'll just need two.
For the replacement cutting edge center steel kit, you can use part # 3371311208 (OEM p# 44894). This includes both the driver and passenger sides as well as the hardware.
expert reply by:
Carla M
0
Product Page this Question was Asked From
Replacement Cutting Edge Half for 8-1/2' Western MVPP or Fisher XV V-Plow - 40-7/8" Long
- Snow Plow Parts
- Fisher Plow Parts
- Western Plow Parts
- Cutting Edges & Blades
- 40-13/16 Inch Long
- Cutting Edges
- SAM
more information >
Continue Researching
- Q&A: Replacement Back Drag Blade for Fisher Snowplow
- Q&A: Is There a Replacement Spindle For a Dexter D44, 4400LB Trailer Axle?
- Q&A: Replacement Remote For a HappiJac Electric Camper Jack System
- Q&A: Correct Replacement Grease Seals for Dexter 4400 Lb Capacity Axle
- Article: Trailer Maintenance Schedule
- Q&A: Replacement Brake Drum Hub Assembly For Dexter D44 4,400LB Axle
- Q&A: Replacement Controller for Lippert Components 6-Point Ground Control 2.0 Electric Leveling System
- Q&A: Troubleshooting Middle Jacks Of Lippert Ground Control 2.0 System Not Retracting After Battery Died