Is It Normal for Brake Lights Instead of Turn Signals to Flash When Using Hazards With Converter
Published 11/13/2019
Question:
Hi. I buy the Curt 2 to 3 wires converter to separate turn and brake lights on a Dodge Challenger 2017 and it works good. But when i turn on the warning signals, it blinks the brake lights instead the turn lights. There is a way to solve this issue? Thank you
asked by: ALVARO G
Expert Reply:
It is perfectly normal for the brake lights to flash when using the warning lights (hazard lights) after installing the Curt 2-To-3-Wire Tail Light Converter # C56196 on a vehicle like your 2017 Dodge Challenger. There isn't a way to resolve the issue due to how the signals come out of the converter box.
Product Page this Question was Asked From
Curt 2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal Fit
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Recommendations on Flat Towing a 2017 Honda Fit with a Manual Transmission.
- Q&A: What Fuses Need to be Pulled to Flat Tow 2017 Honda Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Full Flat Tow Setup For 2023 Ford F-150 and 2026 Jayco Greyhawk
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Q&A: Do Torklift Camper Tie Downs Require Using Spring Loaded Tie Downs
- Q&A: Length of Parking Brake Kit Cable
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Choose a High-Low Adapter