Bolt Hole Pattern Dimensions of Kodiak Disc Brake Caliper Flange KCMB138RDS
Published 11/06/2019
Question:
What is the center hole measurement to center hole measurement on the 4 hole bolt pattern? Also, will this bracket except a 73-87 chevy caliper 3/4 ton? This is for the Replacement Mounting Bracket for Kodiak Disc Brake Caliper - Stainless Steel - 8,000-lb Dexter Axle Item # KCMB138RDS Thank you
asked by: David A
0
Expert Reply:
The distance between the mounting holes of the 4-bolt mounting flange # KCMB138RDS is 3-3/8 inches square. It's hard to say if it would accept a caliper from a vehicle but most likely not.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Replacement Mounting Bracket for Kodiak Disc Brake Caliper - Stainless Steel - 8,000-lb Dexter Axle
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- 8000 lbs
- Caliper Parts
- Hardware
- Mounting Brackets
- Kodiak
more information >
Continue Researching
- Q&A: Spindle Nut That is Slightly Larger Than 3/4 Inch
- Q&A: Bearings and Seal for Replacing UFP Dexter 41062 Hub with Kodiak Hub and Rotor
- Q&A: Kodiak Caliper-Mounting Guide Bolt Replacement Sleeve for Model 250 Caliper
- Q&A: Replacement Sleeve for Kodiak Model 250 Caliper
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Availability of Heat Strip or Heat Pump for Furrion Chill Cube RV AC
- Q&A: How to Determine Correct 7,000 lb Axle
- Q&A: Recommended Disc Brakes for a Dexter 4,400 lbs Axle
- Article: Testing Trailer Brake Magnets for Proper Function