Solution for Carr Mega Step Hitch Step Blocking License Plate
Updated 11/04/2019 | Published 11/02/2019
Products Featured in This Question
Question:
Both of my trucks and my Yukon would have their plates covered by this device what have you got for that?
asked by: Don W
Expert Reply:
If the Carr Mega Step # CARR190011 blocks the license plate on your vehicles then your best option for using the step will be to relocate the plates with a bracket like the Optronics LED # LPL55CB. You can one for each of your vehicles to simply mount the plate in a different location. It just requires a flat surface that's at least 8-5/8" long and 3-1/4" tall. This bracket also includes a built-in LED to illuminate the license plate.
I have attached a short video review that you can check out as well.
Product Page this Question was Asked From
Carr Mega Step for 2" Hitches - Folding - 500 lbs - Mechanical Matte
- Hitch Step
- Flip-Down Step
- Standard Step
- 5 Inch Deep
- 500 lbs
- 2 Inch Hitch
- 14 Inch Wide
- Aluminum
- Carr
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Could Blue Ox Base Plate Kit be Used as Recovery Point for Vehicle
- Q&A: Will WeatherTech BumpStepXL Hitch-Mounted Bumper Protector Interfere with Reverse Sensors or Camera
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Front Mount Trailer Hitch And Spare Tire Carrier For 2013 Ford E-450
- Q&A: Comparing Viair Portable Compressors For A Tandem Axle Airstream Travel Trailer
- Q&A: Can Air Lift Load Controller Compressor System Be Used to Inflate Tires
- Q&A: Can An Air Tank Be Added To Air Lift WirelessAIR Compressor System
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer