Replacement Landing Gear Solution Where Mounting Brackets are 18-1/2 inches Apart
Published 10/17/2019
Question:
need replacement leg set for a 2001 Taho 5th wheel. distance between my welded brackets is 18 and 1/2 inch with a total length of 33 and 3/4 inch. hoping to use my existing motor if possible.
asked by: Steve H
0
Expert Reply:
If you measured your landing gear like in the attached diagram and the frame clamps are 18-1/2 inches apart you have an uncommon spacing which we don't have a direct fit for, but you can use the Landing Gear Set # LG-183708 but would need to have a welder come in and remove your current brackets and weld new ones on that are the appropriate distance apart.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 7001 - 8000 lbs
- Manual Jack
- 35 Inch Lift
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: Looking for Replacement Landing Gear for 1993 Nuwa Snowbird
- Q&A: Replacement Follow Landing Gear Leg for 1998 Fleetwood Savanna 5th Wheel
- Q&A: Landing Gear Replacement for 2011 Keystone Montana
- Q&A: Replacement Landing Gear for 1998 Carriage Carri-Lite RK 732
- Q&A: Landing Gear Replacement Recommendation for 1997 Fleetwood 5th Wheel w/ RBW Landing Gear
- Q&A: Replacement Landing Gear for VMC900R
- Article: What Do I Need To Tow A Trailer?
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Best Landing Gear
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: Converting Your RV Water Heater to Tankless
- Article: How to Replace an RV Roof Vent Cover