What is the Thread Size for the Yakima Replacement Latching Spring Pin
Updated 10/14/2019 | Published 10/13/2019
Question:
What is the thread size on the body of this pin?
asked by: Mike D
Helpful Expert Reply:
I went out to the warehouse to measure the Replacement Latching Spring Pin # 8880582 and while I was able to confirm that it is essentially what you measured (between 23 and 24 mm), I wasn't able to get an exact measurement as the bag it is in is sealed so I ended up having to measure some of the bag too. If you have a Yakima HoldUp, TwoTimer, or FourTimer bike rack then this is an exact replacement part and is compatible for your application.
Product Page this Question was Asked From
Replacement Latching Spring Pin for Yakima HoldUp, TwoTimer, or FourTimer Bike Racks
- Accessories and Parts
- Hitch Bike Racks
- Pins and Clips
- FourTimer
- HoldUp
- TwoTimer
- Yakima
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Parts For The Yakima HoldUp EVO Bike Rack
- Q&A: Does the Replacement 2" Hitch Shank for Yakima HoldUp Bike Racks Work w/ the Older Gray Ones?
- Q&A: Replacement Tilt Pin for Yakima Holdup Bike Rack
- Q&A: How to Install the Replacement Latching Spring Pin Part # 8880582
- Q&A: Replacement Tilt Pin for Yakima HoldUp Bike Rack
- Q&A: Replacement Tilt Pull Pin or Spring Pin for Older 2008-2009 Yakima HoldUp Bike Rack
- Q&A: Which Replacement Pull Pin for Yakima Hold Up Bike Rack
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)