No Power To MaxxAir MaxxFan 3401K
Published 10/10/2019
Products Featured in This Question
Question:
We have this model on our 2018 Coachmen Prism. Suddenly stopped working. It is wired into 12 v only and we replaced the fuse even though the one there seemed to be okay. There is power to the fan. No wall switch or remote. Should we replace the on/off switch pad? Is there a circuit board under it that may need replacing? Thanks
asked by: Kim H
Expert Reply:
I spoke with MaxxAir about the MaxxFan Roof Vent w/ 12V Fan part # MA00A04301K and they informed me that the issue you are having is going to be caused by the control board therefore this is the component you will need to replace. The Replacement Printed Circuit Board and Switch for MaxxFan Roof Vents part # MA10-04301k-v16 is correct for your fan.
Product Page this Question was Asked From
MaxxFan Roof Vent w/ 12V Fan - Manual Lift - 4 Speed - White
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 12V Fan
- Plastic
- White
- MAXXAIR
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended TorkLift Tie Downs for a 2024 F-350 w/a 8' Bed and Factory Hitch
- Q&A: How Much Does The TA35ZR Taskmaster Modular Wheel Weigh?
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Replacement Mounting Bracket for a GloLight Thinline LED Marker Light MCL165AB
- Q&A: Looking for Replacement Shroud for Dometic Brisk Air II AC Unit
- Article: Trailer Wiring Diagrams
- Q&A: Is Butyl Tape Needed When Installing MaxFan Roof Vent
- Article: Spring Towing Readiness Checklist
- Q&A: How Tall is the Vitrifrigo RV Refrigerator w/ Freezer - 4.9 cu ft VT46FR w/ the Compressor?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Replace or Install an RV Roof Vent