Hose Fitting Needed For Demco Hydraulic Brake Kit # 40716-15
Updated 10/04/2019 | Published 10/03/2019
Products Featured in This Question
Question:
I need to cut and install new brake lines, do these need to have a double flare or a bubble/ISO flare on the brake lines? Thank you!
asked by: Chris J
0
Expert Reply:
The Demco Hydraulic Brake Kit # 40716-15 uses a 3/16" Inverted Flare fitting to connect to the brake lines. If you need new mounting hardware for your brakes you can use the Redline Kit for 10" Brake Assemblies # BRKH10A .
expert reply by:
Erik B
0
Product Page this Question was Asked From
Demco Hydraulic Trailer Brakes - Free Backing - Galvanized - Left/Right - 10" - 3.5K
- Trailer Brakes
- Hydraulic Drum Brakes
- Marine Grade
- Free Backing
- Manual Adjust
- Single Servo
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Demco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Will The Kodiak Disc Brake Kit K2R35DKG Fit The etrailer Hub AKIHUB-545-35-G-K?
- Q&A: Should Trailer Brakes All be Changed to Free-Backing
- Q&A: Demco vs. etrailer Hydraulic Dacromet 3,500 lb Trailer Brakes
- Q&A: Replacement Grease Seals for EZ-Loader Axle
- Q&A: How to Bleed Air from the Titan T43397007K Zinc-Plated Brake Actuator
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Replacement Dexter 8-247 Wheel Hub
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Hydraulic Drum Brakes to a Trailer
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide