What Size Does the Plunger Need To Be To Use the Replacement Nylon Socket
Updated 09/10/2019 | Published 09/09/2019 >
Products Featured in This Question
Question:
I saw the question about the dimensions citing the hole diameter.....which means the screw hole. Dumb answer. My question is what is the diameter of the ball socket iteself?
asked by: Warren D
Expert Reply:
The diameter of the plunger that the Replacement Nylon Socket part # DH600S is designed to fit will be around 1/2" give or take 1/8". The plunger must be larger than the opening on the socket in order to hold it in place. That said, in order to make sure you get an exact fit it would be best to just replace both the socket and plunger with part # DH604 for 1" or part # DH605 or 2".
Product Page this Question was Asked From
Replacement Nylon Socket for DH604 and DH605
- Accessories and Parts
- RV Door Parts
- Trailer Door Parts
- Door Holder
- Socket
- Redline
more information >
Continue Researching
- Q&A: Which Caliper Should Be Used With The Dexter 9-3/4" Hub-and-Rotor Assembly DX82UR?
- Q&A: Replacement Hub/Rotor Assembly for a Dexter Boat Trailer Axle DX67HR
- Q&A: Will a Dylux AC System Replace an Older Dometic Model AC w/ 410a Refrigerant?
- Q&A: Availability of Rubber Bumper For Horse Trailer Window
- Q&A: Replacement Window Plunger and Bracket for a 1999 Sooner Horse Trailer
- Q&A: Replacement Hubs for Dexter 8-147 Brake Drums on a 1978 Terry Trailer
- Q&A: Brake Upgrade Reccomendation For My UFP DB-42 Oil Bath Brakes
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Landing Gear
- Article: Trailer Jacks
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them

