Can the Hot-Line LED Trailer Turn Signal Light Bar Be Used In Conjunction With Incandescent Lights
Updated 08/26/2019 | Published 08/24/2019 >
Products Featured in This Question
Question:
Hi, Can this light be used in conjunction with the standard red square light on my utility trailer? My trailer had all incandescent lights before and I want to switch to leds all around. Thanks,
asked by: Michael Y
Expert Reply:
Yes, you can install the Hot-Line LED Trailer Turn Signal Light Bar part # 328-003-6017A and tie this into existing circuits with incandescent lights. The light has three wires; white for ground, brown for running lights, and yellow for turn signals. The wires can be attached using the Deka Heat Shrink Butt Connectors part # DW05744-5.
Product Page this Question was Asked From
Hot-Line LED Trailer Turn Signal Light Bar - Submersible - Amber Lens
- Trailer Lights
- Tail Lights
- Turn
- Surface Mount
- Submersible Lights
- LED Light
- 15-1/4L x 1-1/4W Inch
- Amber
- Command Electronics
more information >
Continue Researching
- Q&A: What Kind of Batteries Does the Progressive Dynamics PD4655V Work with?
- Q&A: Recommended Lithium Compatible Replacement For A WFCO 8955PEC Power Center
- Q&A: Replacement Lower Section for Magnetek 63450
- Q&A: Correct Replacement for VD218105A Fan Motor
- Q&A: What Bulb Does The Optronics Round Trailer License Plate Light With Mount Ears Use?
- Q&A: Recommended Round LED License Plate Light Similar to Optronics Light with Mount Ears
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Do You Have Hubs and Brakes Compatible with Dayton Fayette 9349 Axles from 1979 Travel Trailer?
- Article: Can I Put Wallpaper in My RV?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012

