Installing Redarc Tow Pro Elite in 2020 Jeep Gladiator

Updated 08/20/2019 | Published 08/19/2019

Products Featured in This Question

Redarc Tow-Pro Elite Brake Controller - Dash Knob - Off-Road Mode - Up to 3 Axles - Proportional

(1676)

$290.00

10 Gauge Wire - Blue Primary - Per Foot

(104)

$1.89

Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers

(159)

$57.19

Question:

What adapter harness is required for a 2020 Jeep Gladiator?

asked by: Michael C

Expert Reply:

I did some checking and it looks like your 2020 Jeep Gladiator with the tow package has to have the Redarc Tow Pro # RED44FR brake controller hardwired to the 7-way connector at the rear of it.

For a wiring kit to install the brake controller to the 7-way you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.

Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.

expert reply by: Jameson C