Can a Trailer Battery On a Dump Trailer Be Charged Using The 7-Way Trailer Connector
Updated 03/02/2012 | Published 02/28/2012
Products Featured in This Question
Question:
When we try to charge our deep cycle battery by trickle charging it burns up our harnesses. How can we keep that from happening?
asked by: Jeff
Expert Reply:
First, a trailer battery cannot be charged up from the 12 volt circuit on a 7-Way connector. The 7-Way can only provide a maintenance charge which will keep the battery at is current charge level. It is possible that the battery is back feeding when the truck is turned off and the trailer is still connected.
You may also need to increase the size of the wiring. Wiring that is too small a gauge may not be able to handle the power draw. A short circuit or corrosion in the trailer connectors could also be a concern. Clean out the connectors, front and back, and make sure the 12 volt circuit wiring is show bare wire and rubbing against something metal.
The battery may already be fully charged and adding any additional current is actually overcharging the battery. You should have the battery tested locally to determine if the battery is still good.
Then, I recommend disconnecting the battery from the 12 volt circuit on the 7-Way and using a regular battery charger like # CTEK56353, to charge and maintain the battery. Unlike trickle chargers, this charger will not overcharge the battery.
Product Page this Question was Asked From
Miro-Flex LED Clearance or Side Marker Light w/ Chrome Bezel - Submersible - 3 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 4-3/16L x 1-3/8W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Solution for Needing Replacement GE Upper RV AC Unit ARC15AACBL2
- Q&A: Changing Out Carrier V AC Units On 2006 Damon Astoria
- Q&A: Where is Toilet Model Info Listed on Dometic RV Toilets
- Q&A: Replacement Lens for Trailer Taillight SAE AP2 99 DOT
- Q&A: Replacement Breakaway Switch A UPG Model 42914 Breakaway Kit
- Q&A: Wiring Diagram for Kwikee Step Motor Conversion/Upgrade Kit # LC379145
- Q&A: How Much Do the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches Weigh?
- Article: Trailer Lighting Requirements
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box