Will Phoenix USA QuickTrim Hub Cover # PXQT545BHS Fit with Bearing Buddy

Question

Question:

Are these deep enough to cover dexter axles with bearing buddies installed?

asked by: Jerry C

0

Expert Reply:

To determine if a Bearing Buddy would fit you will need to measure the Bearing Buddy. If it is less than 2-1/4 inches in diameter and sticks out less than 2-3/4 inches from the surface of the wheel (at the lug nuts) then a Bearing Buddy will fit with the Phoenix USA QuickTrim Hub Cover # PXQT545BHS.

expert reply by: Jameson C

0

Answer 1

The Phoenix USA QuickTrim Hub Cover for Trailer Wheels - 5 on 4-1/2 - ABS Plastic - Chrome - Qty 1 #QT545C does not require any specific orientation for installation. You simply align the bolts with cap and press it into place. I've attached a…

view full answer...

Answer 2

Hey Dan, I'm happy to help! For a 3500 lb axle and a 5 on 4-1/2" bolt pattern, you can use the CE Smith Trailer Hub Assembly #CE13511 which is pre-greased with a carrying case if you don't need the galvanized option or the EZ Lube…

view full answer...

Answer 3

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 4

Hey Andrew, The CE Smith Trailer Axle Beam with Studded Hubs #CES84XR is a 1-1/2 inch square axle tube.

view full answer...

Answer 5

The maximum life span of a trailer tire is typically 5 or so years, so you're absolutely correct in thinking they should be replaced. They're probably pretty cracked up and dry-rotted at this point. If at all possible, I'd go with the…

view full answer...

Answer 6

I was able to confirm that the Kenda 5.70-8 Bias Trailer Tire with 8 White Wheel - 5 on 4-1/2 - Load Range D #AM30155 are the correct fit for your trailer. I was also able to confirm that your trailer has 3,500 lb Dexter axles so you will use the…

view full answer...

Answer 7

If the Phoenix USA QuickTrim Hub Cover for Trailer Wheels #QT545C will fit depends on the dimensions of the grease caps you have. The diameter of the interior at its narrowest point (nearest to the outside) is right around 2-1/4-inches, the depth…

view full answer...

Answer 8

According to information we have looked at in the past, the Shorelander SS734 fits the same dimensions as the standard #84 spindle. With this being the case I recommend using the Easy Grease Trailer Idler Hub Assembly #AKIHUB-545-35-EZ-K for your…

view full answer...

Will Phoenix USA QuickTrim Hub Cover # PXQT545BHS Fit with Bearing Buddy

Product Page this Question was Asked From

Continue Researching