Distance Between Mounting Holes of Draw Tite Hitch part # 75561
Published 07/12/2019 >
Question:
I have a question regarding product: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2 Item # 75561 If possible, could you give me the measurement of distance between the two sets of holes used for mounting these brackets. Thank you.
asked by: Mark E
0
Expert Reply:
The distance between the sets of mounting holes on the Draw Tite hitch part # 7561 is 37-3/8 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is a confirmed hitch to fit a 2022 Volkswagen 4WD SEL?
- Q&A: Is There a 2" Trailer Hitch Available for a 2021 Toyota Corolla Hatchback?
- Q&A: Why Wouldn't Hitch for 2021 Mazda CX-5 Have Flanges that Line Up Properly
- Article: Roof-Mounted Ski and Snowboard Carriers
- Q&A: Choosing Correct Hitch Tongue Weight Capacity for Using a 4-Bike Platform Bike Rack on Honda CR-V
- Q&A: Will The Curt Hitch C38JR Fit A 2024 Volkswagen Toas 4motion AWD
- Q&A: Can You Use The 3rd Brake Light Logic Module With A 4-Pole
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Installation of DrawTite # 75778 Class III Trailer Hitch on 2010 Infiniti FX35

