Will the Timbren Rear Suspension Enhancement System Fit a Lowered 2001 Chevy Silverado
Updated 06/20/2019 | Published 06/19/2019
Products Featured in This Question
Question:
What is the total height of this product including the bracket and the rubber. I am trying to figure out if it is too tall for my lowered truck.
asked by: Justin M
Helpful Expert Reply:
The overall height of the Timbren Rear Suspension Enhancement System part # TGMRCK25S is 7-1/4" with the included spacer installed or 6-1/4" without the included spacer installed. If the 6-1/4" is too tall for your lowered 2001 Chevrolet Silverado you can use the SumoSprings Solo Custom Helper Springs part # SSR-209-40 for 1500 or part # SSR-211-54 for 2500/3500 models. If you take a bread knife, you can trim these down to fit the space you need them to.
Product Page this Question was Asked From
Timbren Rear Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Rear Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Overall Height of Timbren Spring Kit part # TGMRCK25S
- Q&A: Timbren Suspension Kit that Fits 2005 Chevy Silverado 1500HD
- Q&A: Timbren Kit Recommendation for 2006 Chevy Silverado 2500HD
- Q&A: Timbren or Hellwig Load Pro for 2023 Chevy Silverado 2500
- Q&A: Recommended Upper Doors For 1989 Jeep YJ With Steel Lower Doors And Hard Top
- Q&A: P3 Brake Control Shows No Trailer Connected Even with Trailer Connected to 2002 Ford F-150
- Q&A: Location of Brake Controller Fuse on a 2001 Chevy Silverado
- Article: How to Mount a Truck Bed Camper
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Trailer Tire Sizing
- Article: Ram Trailer Tow Prep Package
- Article: Anti-Rattle Devices
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers