What Circuit Tester is Used in the Installation Video for the Peak Wireless Backup Camera
Updated 02/08/2012 | Published 02/04/2012
Question:
I watched the installation video instruction and I must say it was well done. My question is what is that tool you used to check the live wire for reverse? Do you sell that tool? Thanks.
asked by: Miguel M
0
Expert Reply:
The circuit tester that our installer used to test the reverse light wire when installing the Peak backup camera is the Draw-Tite Circuit Tester, # PTW2993.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Trailer Wiring Diagrams
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailers Right Tail Light Stays on Even While Unplugged
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Warm White 4-1/4" Diameter Puck Light
- Q&A: Troubleshooting Right Side Trailer Lights Not Working, Left Side Working Correctly
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Use a 4 Way Vehicle Connector with 7 Way Adapter and the Curt Echo Brake Controller?
- Q&A: Troubleshooting Blown Vehicle Fuses Every Time Trailer is Connected
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer