How Do the B&W Rubber Covers Fit Turnoverball Hitches
Updated 05/15/2019 | Published 05/14/2019
Products Featured in This Question
Question:
How does it mount in
asked by: Karen
0
Expert Reply:
The B&W Rubber Cover # BWGNXA1710 attaches to the backside of a flipped over hitch ball. The four rubber plugs hold the cover to the bottom of the ball with a friction fit. If instead you have a totally open ball socket the cover you'd need is the part # BWGNXA1715.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
B&W Rubber Cover for Stowed Turnoverball
- Accessories and Parts
- Gooseneck Hitch
- Covers
- B and W
more information >
Continue Researching
- Q&A: Where Does The Red Wire Install to On the Roadmaster Brake-Lite Relay Kit 2007 Hummer H3
- Q&A: Is The MORryde GooseTech Compatible With A Short Bed 2024 Ram 2500?
- Q&A: Is the Gen-Y or MORryde GooseTech Better to Replace a Lippert 1621 Pinbox?
- Q&A: Recommended 5th Wheel Hitch and Installation Hardware for a 2024 Toyota Tundra
- Q&A: Comparing Suspension Upgrades For Heavy Towing With 2024 Ford SuperDuty
- Q&A: Do You Have a Lifting Block for a 1992 Featherlight Horse Trailer w/ Torsion Axles?
- Q&A: Will Curt T-Connector Vehicle Wiring Harness Fit 2025 Ford F-350
- Article: Ram Trailer Tow Prep Package
- Article: Best Air Bag Suspension 2025
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Maintenance Schedule
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams