Mounting Hardware Required for Pre-Drilled Round Rubber Trailer Bumper
Updated 05/13/2019 | Published 05/10/2019
Question:
Where can I buy mounting hardware for the round bumper from you for a horse trailer
asked by: Bette H
0
Expert Reply:
The Pre-Drilled Round Rubber Trailer Bumper # D3-96 simply requires 9/16" bolts, which can be found at any local hardware store. If you are keeping it at 96" and not cutting the bumper down to size, you will need 9 of these bolts.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 3" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- Bolt-On
- 3 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Continue Researching
- Q&A: Replacement Rubber Bumper For A Horse Trailer With A 81-1/2" Bumper Length
- Q&A: What hardware is used to attach the 96inch predrilled rubber bumpers?
- Q&A: Does etrailer Sell The Rubber Bumper For Trailers D4-96 ?
- Q&A: What Slide-Out Actuator will Replace My Kwikee with Part Number 907202104?
- Article: Trailer Wiring Diagrams
- Q&A: Will TowSmart T-Connector Wiring Harness Fit 2016 Chevy Colorado
- Q&A: Replacement for 84 Inch Bumper on Horse Trailer
- Q&A: Coupler Repair Kit for the Bulldog Gooseneck Coupler 028900
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Lighting Requirements
- Article: Trailer Maintenance Schedule