Correct Replacement Ceiling Garnish for Ventadome V2094 With Fan in Birch White

Question

Question:

I have found the correct screen replacement for my 2004 Hitchhiker ventadome V2094 fan. But cant find the ceiling garnish that fits it. All Ive found say they are 14 1/4x14 1/4. While my garnish is 13inch across where it meets the screen. Do you carry the right garnish in Birch white?

asked by: Joe A

0

Expert Reply:

For your Ventadome V2094 fan, I am glad you were able to find the Replacement Screen Frame with Screen, Rocker Switch, and Wire for Ventline Roof Vents - Birch White # BVC0573-31R or for just the screen # BVD0434-31. The proper ceiling garnish for your vent will depend on your roof thickness. We have the following that are all confirmed to fit:

Ceiling Garnish for Ventline Roof Vent - 5-1/8" Leg - 14-1/4" x 14-1/4" - Birch White # VA0445-29
Ceiling Garnish for Ventline Roof Vent - 4-1/4" Leg - 14-1/4" x 14-1/4" - Birch White # VA0445-28
Ceiling Garnish for Ventline Roof Vent - 3-1/8" Leg - 14-1/4" x 14-1/4" - Birch White # VA0445-27
Ceiling Garnish for Ventline Roof Vent - 2-1/8" Leg - 14-1/4" x 14-1/4" - Birch White # VA0445-26
Ceiling Garnish for Ventline Roof Vent - 1-1/8" Leg - 14-1/4" x 14-1/4" - Birch White # VA0445-25

expert reply by: Jason S

0

Answer 1

From my research the VD0434 model number is the screen for a Ventline roof vent. We carry two replacement lids for the Ventline roof vents. It is more than likely you need the Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent part…

view full answer...

Answer 2

Is it just a roof vent cover you are looking for? If so, I have linked the page to your options which will be based on the hinge style present on your assembly. I've attached a photo of the 4 style options to assist. If you are looking to replace…

view full answer...

Answer 3

Essentially you need to measure the height of the garnish from above the lip to the very top. If you can't find one that fits exactly you can get a garnish that's too large and cut it down to size.

view full answer...

Answer 4

The Ventline Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - 14-1/4" - White - Birch Trim #V2094SP-28 has different length ceiling garnish pieces available. This is dependent on the size gap you have. In the birch white we have: Ceiling…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

The replacement screen frames for the trailer roof vent on your 2011 Grey Wolf come in two different colors. For the Polar White you will need part #BVC0573-41. For the Birch White you will need part #BVC0573-31.

view full answer...

Answer 10

Hey Audrey, To replace your Ventline VD0434 Roof Vent screen and frame you would need the Replacement Screen Frame with Screen for Ventline Ventadome Manual Lift Roof Vents #BVC0573-31. This comes in birch white to match your vent's color.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Correct Replacement Ceiling Garnish for Ventadome V2094 With Fan in Birch White

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching