Troubleshooting Trailer Lights That Dont Work with 2017 Toyota Tacoma but do with Chevy Silverado

Question

Question:

My neighbor has a utility trailer that works fine with his Chevy Silverado 1500 but when I hook it up to my 2017 Tacoma none of the lights work. Suggestions?

asked by: Bill

1

Helpful Expert Reply:

Since the trailer is working just fine with another pickup you will want to check any fuses or relays that carry the trailer lighting functions. I tried looking this up in the online version of the owner's manual for your 2017 Toyota Tacoma but there isn't a list for what the various fuse locations are for. These may be listed on the cover for the fuse compartment.

If the fuses and relays look good then you need to use a tester like part # PTW2992 to check the pins on your 4-Way like part # C56349 or 7-Way like part # 22117.

If you are getting the correct lighting signals then the only other thing to do would be to take your pickup and the trailer in to a shop so they can physically inspect what is going on.

expert reply by: Jon G

1

Answer 1

Without knowing what brake controller you have I will venture to guess that the OL code you are seeing is an over load code. The OL or overload error code indicates a short in the brake output circuit. Start by examining the trailer connector. Make…

view full answer...

Answer 2

An OL error code would indicate an overload error. The cause of this is most likely a bad ground or a short to the blue brake out put wire. The first thing I would check is the connector on the back of your vehicle. Any dirt or corrosion can be…

view full answer...

Answer 3

Hey Kolton. To add a hitch to your 2024 Grand Design Imagine 2970RL, I recommend the Curt item #13703. This is a universal hitch that bolts or welds directly to your Grand Design's frame. The include brackets can be adjusted to fit frames from…

view full answer...

Answer 4

Hey Brian. The Curt Trailer Connector Adapter item #C57672 is going to install in the same way on your 2023 F-150 as it did on the video we made for a 2021 F-150. Those trucks are the same generation but I can not guarantee the wiring colors are…

view full answer...

Answer 5

To begin you will want to begin testing the different circuits of the Step Control Module #LC334850. The brown wire goes to the door switch to tell the steps when to open and close. The yellow wire runs to an ignition switch so that the steps know to…

view full answer...

Answer 6

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

view full answer...

Answer 7

Yes, you can bypass the door switch on your Lippert steps. You can do this by connecting the two wires together. If your steps operate then you know the switch is bad and can replace it with the Replacement Door Switch #LC301694 if you have the…

view full answer...

Answer 8

The Kwikee Control Box #909506000 has been discontinued by the manufacturer. The replacement part is determined by the date of manufacture which you can determine by looking at the current part which will have a date on it. If not, you can supply the…

view full answer...

Answer 9

The fuse for power steps on a motorhome, like part #LC3658373, will be found on the 12V power wire that runs to your battery bank as opposed to a fuse in the power center like what you find on a vehicle. What you're looking for is a fuse holder…

view full answer...

Troubleshooting Trailer Lights That Dont Work with 2017 Toyota Tacoma but do with Chevy Silverado

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching