Door Locks on 2019 Chevrolet Colorado Do Not Work After Pop & Lock Install
Updated 04/09/2019 | Published 04/07/2019
Question:
I just installed my pop lock on my 2019 Colorado and once I plug it in the locks on the truck dont work but when I unplug it they come back
asked by: Chad
Expert Reply:
I spoke to my contact at Pop & Lock about the Pop & Lock Custom Tailgate Lock part # PAL8140 for your 2019 Chevrolet Colorado and they seem to think you have the device tied into the wrong circuits. The correct circuits that you will need to use will be located at the back of the 27 pin plug coming from the PCM, under the driver dash.
On this 27 pin plug there is a brown/yellow wire on the 4th pin that is used for the lock signal and then a gray wire on the 1st pin that is used for the unlock signal. These are the wires that you will need to attach to the blue and green wires on the Pop & Lock Custom Tailgate Lock. If the lock works opposite of how it should, then you will just need to switch the blue and green wires as that is what the instructions say to do but it does not matter if you attach the gray wire on the vehicle to the green or blue wire on the kit to start with.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Alike
- Vehicle Specific
- Black
- Pop and Lock
more information >
Continue Researching
- Q&A: Will The Progressive Dynamics Transfer Switch Prevent A Power Loop With An Inverter
- Q&A: Wiring In The Progressive Dynamics Automatic Transfer switch # PD5110010Q
- Q&A: 2-1/2 Inch Shank for Eaz-Lift Weight Distribution Hitch
- Q&A: Towing Mirror Options for 2015 Chevrolet Silverado 2500 LTZ HD Duramax
- Q&A: Recommended Tailgate Lock System for a 2015 Chevrolet Silverado 1500 LTZ
- Q&A: Recommended Brake Controller for 2018 Nissan Titan With Factory 7-Way
- Q&A: How Do you Mount the Complete Propane Tank Holder Mounting Kit to the Trailer Tongue