Recommended Easiest Way to Isolate Brake Signal for High Mounted Third Brake Light
Published 02/24/2019
Question:
Hi - I have a trailer with the standard flat-four connector and I want to install a third high mounted LED brake light. I can hook up the running light w/o a problem by tapping into eithe side tail light but since the turn signal and brake light are on one bulb, it would not work. Is there a diode kit or something available that filters out the turn signal while braking or is there a simpler solution? Thanks
asked by: Ulrich N
Helpful Expert Reply:
There is a simple solution to get the isolated brake signal from your combined turn signal and brake wiring. You will simply use the Pacer Performance 3rd Brake Light Logic Module # PP20-702. The module filters out the unwanted turn signal. This will work with incandescent or LED lights.
Product Page this Question was Asked From
Featured Help Information
Instructions
Continue Researching
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Q&A: Wiring and Connectors to Power 2025 Ford Maverick Truck Cap 3rd Brake Light
- Q&A: Solution For 2023 Ford Maverick For Third Brake Light Wiring for Camper Shell
- Q&A: How to Wire a Third Brake Light on Trailer
- Q&A: Making 7-Way to Camper Shell Third Brake Light Adapter
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Holiday 2025 | Best Gifts for Towers
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: How To Wire Dome and Third Brake Light On Leer Camper Shell
- Q&A: 3rd Brake Light Module Blinking With Turn Signals
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)