What are the Dimensions of the # RA-3 Hedge Trimmer and Chainsaw Rack For Enclosed Trailers
Updated 11/30/2011 | Published 11/29/2011
Question:
What are the dimensions of this item? thank you
asked by: Cesc
0
Expert Reply:
The dimensions of the # RA-3 hedge trimmer or chainsaw rack are 33-1/2 inches overall length by 13-3/8 inches wide. From the hook where the handle would hang to the center of the cross bar with bungee the measurement is 13-3/4 inches.
There are also several mounting holes in the rack starting at 2 inches from the top, then 12 inches, 19 inches and finally 31-3/4 inches.
I produced a short video showing the dimensions of this rack for you to review, see link.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Rack'Em Hedge Trimmer Rack for Enclosed Trailers
- Trimmer Racks
- Enclosed Trailer
- 1 Trimmer
- Locks Not Included
- RackEm
more information >
Continue Researching
- Q&A: Timbren Rear Axle Suspension Enhancement For a 2023 Ford F-350 Dually 4x4
- Q&A: 7 Inch Monitor to Replace AOM713WP Monitor on Voyager RV Observation Camera System
- Q&A: Will MORryde Equalizers MR87ZR Replace 5-3/4" Equalizer On Travel Trailer?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Will the Camco Propane Tank Cover Part # CAM40565 Fit Over a 20Lb Tank with Regulator and Bracket
- Q&A: How Can I Mount a 20 LB Propane Tank to a Trailer Hitch on my Camper Van
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Direct Replacement for Carrier Air V RV Air Conditioner