Is Amber Tear Marker Light M116A a 1-Wire Design
Updated 01/29/2019 | Published 01/28/2019
Products Featured in This Question
Question:
Is this a 1wire light of a 2wire light .Does not say in description.
asked by: Wilfred D
0
Expert Reply:
Peterson Teardrop Marker Light # M116A is a 1-wire light, meaning that the ground is established by the metal mounting flange and the 1 wire is for +12V. This means the flange should ideally make bare metal to bare metal contact with the mounting point on the trailer. It is also a good idea to prevent corrosion by applying dielectric grease # 11755 at the installation point.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Peterson Clearance or Side Marker Trailer Light w/ Reflector - Submersible - Teardrop - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Triangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 5-3/8L x 1-13/16W Inch
- Amber
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Looking For A Replacement Wesbar Side Marker Light For My Boat Trailer
- Q&A: How Does The Ultimate Trailer Jack Fold Up For Travel
- Q&A: Replacement Rooftop AC Unit For A Dometic Duo-Therm 630035.331
- Q&A: Recommended Replacement for Atwood GC10A-2 RV Water Heater
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Replacement Rotors and Brake Pads For EZ Loader Boat Trailer With Kodiak 3,500LB Disc Brakes
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Best Boat Trailer Jacks
- Article: Boat Trailer Guides: Which are the Best?
- Article: How to Bleed Your Trailer Surge Brakes
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Set the Right PSI for Your Air Bags