What is the Usable Length of the Heavy Duty Linchpin, # LP716HD
Published 11/28/2011
Question:
Can you provide me with the actaul length of the linchpin? What does the usable length mean? I need to put the pin through two holes about 1.5 apart, so I need about 1.625 of clear shaft before the ring hits...
asked by: Greg
0
Expert Reply:
The usable length of the Heavy Duty Linchpin, # LP716HD, is from the end of the pin up to the head that holds the ring (because the head will not fit through the 7/16 inch diameter hole, it is not part of the usable length). The usable length is 1-3/4 inches (1.75) so it will fit your application.
I have made a picture that shows the usable length for you.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Heavy Duty Linchpin - 1-3/4" Long x 7/16" Diameter
- Hitch Pins and Clips
- Linchpin
- 1-3/4 Inch Long
- 7/16 Inch Diameter
- 1-3/4 Inch Span
- Redline
more information >
Continue Researching
- Q&A: What Are the Frame Tabs Called That a 5th Wheel Pin Box Mount to?
- Q&A: Recommended Equa-Flex Cushioned Equalizer for 2007 Keystone Cougar 30 Foot Long 5th Wheel Trailer
- Q&A: Kuat Transfer V2 vs Kuat Sherpa 2.0 For Use on a Travel Trailer
- Q&A: Replacement Wheel and Tire Possibilities for a 4.30-12 Wheel and Tire on a Landscape Trailer
- Q&A: Best Flat Tow Setup For 2005 Jeep Wrangler Rubicon With Park Sensor System
- Q&A: 55 Amp Power Converter For a Parallax 7300 Power Center Compatible With Lithium Batteries
- Article: Converting Your RV Water Heater to Tankless
- Q&A: Recommended TPMS For Flat Towed 2007 Toyota Tacoma