Replacement Roadmaster Base Plate Arms for the Existing Base Plate Brackets
Updated 12/17/2018 | Published 12/16/2018
Products Featured in This Question
Question:
hello, Can I get just the Male end of the brackets that slide into the ones that mount on the vehicle? I have some that were on a truck I bought but dont have the other end or half. Just seeing if I can get those or not, thanks.
asked by: Luke
Expert Reply:
The Roadmaster XL Base Plate Kit - Removable Arms # 131-15 will use the Roadmaster Replacement Arms for Base Plate Kits # RM-ARMS. Because these will be custom fit, they are only available in pairs and are non-returnable. There is a form to fill out for the correct part attached. Please allow the stated time on the product page for delivery.
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Kit - Removable Arms
- Tow Bar Base Plate
- Removable Draw Bars
- Hitch Pin Attachment
- Partially Hidden
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Must-Have Flat Towing Components
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Flat Towing Equipment For A 2001 Jeep Wrangler
- Q&A: Replacement Arms To Convert Crossbar Baseplate To Direct Connect On a 2000 Jeep Wrangler
- Q&A: Parts Needed to Flat Tow a 2002 Chevy Silverado 2500 4x4 behind an RV
- Q&A: Can I use a Demco Tow Bar with Roadmaster Base Plates?
- Q&A: Tail Light Wiring Differences Between the 2008 Ford Edge and the 2011-2013 Ford Edge
- Q&A: Parts Needed to Flat Tow a 2014 Buick Enclave with Roadmaster Falcon 2 Tow Bar
- Q&A: Replacing Tow Bar Wiring 4-Way Connector with a 6-Way on a 2011 Lincoln MKX