Can Just Front Axle Timbren Kit be Installed on 2011 Toyota Tundra
Published 11/02/2018
Question:
I have a 2011 Toyota Tundra Double Cab with 4.6L engine. It is equipped with a Fisher Minute Mount and RD Blade. Weight rating is OK per Fisher eMatch but I would like a little more clearance when the blade is suspended in mid air. Is it OK to mount the Timbren TTOFTUN4 to the front and leave the rear stops alone?
asked by: Christopher H
0
Expert Reply:
Yes, you can install Timbrens on the front axle of your 2011 Toyota Tundra that you plan to use to plow with. For that we have the # TTOFTUN4 that you referenced which would fit and work well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Timbren Front Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Front Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Timbren Rear Suspension Enhancement Recommendation for 2023 Toyota Tacoma
- Q&A: Comparing Timbren Suspension Enhancement for 2018 Toyota Tacoma
- Q&A: Will Hellwig EZ-1000 Helper Springs Fit 4X4 1991 Toyota Pickup
- Q&A: Recommended Spacers for a Firestone Ride-Rite Air Bag Kit
- Q&A: What Suspension Upgrade do I Need for My 2025 Tundra with In-Bed Camper?
- Q&A: Solution for Needing to Replace Bargman L-400 RV Latch on Travel Trailer
- Q&A: B&W Turnover Gooseneck for 2015 Ford F-350 Cab and Chassis
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Determine Tire/Wheel Diameter