Is There a Thickness Requirement for Installing Brophy D-Ring Tie Down Anchors SR15-C
Published 10/31/2018
Question:
What thickness should the trailer steel be if bolting on item # SR15-C?
asked by: Travis
0
Expert Reply:
The Brophy D-Ring Tie Down Anchor # SR15-C that you referenced does not have a thickness recommendation for attaching to a steel floor. Basically any steel that would be thick enough to work as a trailer floor would be adequate.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 3-1/2" Wide - Surface Mount - 1,600 lbs
- Trailer Tie Down Anchors
- D-Rings
- Universal
- Zinc-Plated Steel
- 1600 lbs
- Bolt-On
- Folding
- Surface Mount
- Brophy
more information >
Continue Researching
- Q&A: Difference Between Pro Series Drop Leg Square Jacks PS1400950376 And PS1400960376
- Q&A: Where do I Install D-Ring Tie Downs on a 6x10 Wood Bed Utility Trailer
- Q&A: Recommended Replacement Tail Lights For Obsolete KD 460 Tail Light Lenses On Hay Bale Truck
- Q&A: Recommended Replacement Jack For Shelby Bolt On Boat Trailer Jack
- Article: Cargo Tie-Down Methods
- Q&A: Recommendation for Re-Using Deck Board Screw Holes When Replacing Wood on Trailer
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
- Q&A: How To Power Third Brake Light On Camper Shell Using 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Basics of Tie-Down Anchors
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams