Clearance Needed to Install LED Trailer Light # STL201RFMB
Updated 10/28/2018 | Published 10/27/2018
Products Featured in This Question
Question:
If this light is installed in a closed box, how deep does the box need to be? I see that the dimension for the light depth is 1 5/8inch but how much more do the plugs stick out the back of that?
asked by: Tice
Helpful Expert Reply:
I went to our warehouse and put together the light, part # STL201RFMB, with both the 3-wire, part # A45PMB, and 2-wire, part # A42PMB, pigtails.
With both pigtails plugged in I measured abouut 2-1/4 inches from the front of the light to where the wires enter the connector. You need a little more space than this for the wires to have room to bend so I'd guess you want at least 2-1/2 inches at the very least.
Product Page this Question was Asked From
Fusion LED Trailer Tail Light - Stop, Tail, Turn, Backup - Submersible - Round - Red/Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Stop
- Tail
- Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Red
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Which Pigtails Are Needed For The GloLight LED Trailer Light STL201RFMB?
- Q&A: What Size Hole is Required to Install GloLight LED Trailer Tail Light # STL201RFMB
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Hitch Dimensions for Fitting Hitch to 2012 Ford F-450
- Q&A: Dimensions of Curt Trailer Hitch Receiver Part # C15810
- Q&A: Drop Measurement of Curt Class V Trailer Hitch # C15810
- Q&A: Will Curt Class V Hitch # C15810 Fit a Ford F-250/F-350 With a Full Size Spare Tire
- Article: Determining Trailer Tongue Weight
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop