What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
Published 10/23/2018
Question:
On this kit, does the width of the spring matter?
asked by: Thomas H
0
Expert Reply:
Yes, the spring width would matter when using the Dexter Over Under kit part # K71-384-00 that you referenced. If you check out the picture I attached you'll see that if the spring was too wide the u-bolt holes of the plate wouldn't fit around it. You'd want to use this kit with 1-3/4 inch wide leaf springs.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Search Results: over under conversion kit
- Shop: Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs - 2-1/4" Links
- Article: How to Raise Your Travel Trailer Height
- Q&A: Solution for Axle Stuck to Leaf Spring During Over-Under Conversion
- Q&A: Is It Required The Spring Seat Be Welded to Trailer Axle
- Q&A: Recommended Over-Under Kit for Tandem Axle Trailers
- Q&A: Is it Possible to Raise Suspension of Shadow Cruiser Fun Camper
- Q&A: What are the Bolts on the Spring Seats for on Dexter Over Under Conversion Kits
- Search Results: dexter springs
- Shop: U-Bolt Plate for 4" Diameter, Round Trailer Axles with 2" Wide Springs
- Video: Stromberg Carlson Trailer Jack LG-BRACKETS Review
- Article: Best Camper Jacks
- Shop: Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Shop: Replacement 22-1/2" Left Rear Leg for Lippert Ground Control 3.0 Electric Leveling System
- Shop: Spring-Loaded Pull Pin for etrailer and Ram 5th Wheel Landing Gear
- Shop: Replacement Follow Leg for Stromberg Carlson Landing Gear - 33-1/2"
- Q&A: Can Trailer Landing Gear Be Damaged Internally By Lowering Too Far?
- Q&A: Weight Capacity for Ram Landing Gear 12-Volt Motor Kit