Dimensions of Master Lock Armored Cable Gun Lock 107KADSPT
Published 10/19/2018
Question:
What is the size of recieving hole in lock? Where cable makes the completed lock? Inches please not mm. Thank You
asked by: Joe Z
0
Expert Reply:
I measured the Master Lock Armored Cable Gun Lock, item # 107KADSPT, and found the receiving hole that accepts the end of the cable is approximately 3/16-inch. The overall size of the lock housing is approximately 1 x 1-1/4-inches.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Master Lock Armored Cable Gun Lock
- Hunting and Fishing
- Gun Storage
- Gun Lock
- Master Lock
more information >
Continue Researching
- Q&A: What Air Pressure Should I Run in My Trailer Tires?
- Q&A: Availability of Coupler Lock With a 5/16 inch Pin Diameter
- Q&A: Is it Possible to Lock the Buyers Products Stake Pocket Spare Tire Carrier # 3375201012
- Q&A: What is Difference Between Trailer Bearings L44649 vs L44643
- Q&A: What Does Yellow Wire of 7-Way Molded Trailer Wire Connector H20044 Wire To
- Q&A: Replacement Clearance Lights For Glo Brite 122r/122y
- Q&A: Replacement Lens for Glo-Brite 122R and 122Y
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing