How Does the Putco Tailgate Cap Part # P53614P Install
Published 10/17/2018
Question:
How is the tailgate protector installed? Adhesive, screws or rivets?
asked by: Robert
0
Expert Reply:
The Putco Tailgate Cap part # P53614P installs using self tapping screws which are included for you. They install on the inside of the tailgate so they won't be as visible. I am sure you could also use some 3M double sided adhesive for a less permanent install if you like. This can be acquired at most local auto parts stores.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Putco Tailgate Cap - Stainless Steel
- Truck Bed Protection
- Bed Rail Trim
- Tailgate
- Top of Rail
- Stainless Steel
- Putco
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Keys for Diversi-Tech Ball Mount
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Recommended SnapPad Jack Pads for a HWH Leveling System on a Motorhome
- Article: Trailer Lighting Requirements