Where Do Wires Run on Uni-Lite LED Clearance and Side Marker Light # MCL11RKB
Published 10/10/2018
Question:
Do I connect one lead to the trailer hardness and the other to the frame of the trailer? Is polarity an issue to deal with?
asked by: Pedro M
0
Expert Reply:
On the Uni-Lite LED Clearance and Side Marker Light # MCL11RKB the black wire gets the 12 volt power source and the white wire goes to ground. The light would not work if you reversed the polarity.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Looking For Conventional Ramp Door Spring For 7' Wide Trailer With Extremely Heavy Door
- Article: Trailer Wiring Diagrams
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Comparing 12" Tire Options ST145/R12 And 5.30-12
- Q&A: Difference Between Tire Sizes 4.80-12 and 5.30-12
- Q&A: Diameter of the Replacement Footplate Keeper Pin for etrailer and Ram Square, Direct Weld Jacks
- Q&A: Best Lug Nuts for 2021 Keystone Cougar 29RKS
- Q&A: Lift Kit Needed for Lippert Torsion Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)