How Does LED Work Light # UCL24CFB Wire
Published 10/03/2018
Products Featured in This Question
Question:
I have a Honda pioneer and would like to use this as a rear facing light. How does it ge Wired in? Do you have any photos or instructions?
asked by: Mark G
0
Expert Reply:
The LED Work Light # UCL24CFB that you referenced wires in pretty easily. The red wire gets 12 volts positive and the black wire goes to a ground and it will light up. You'd want to use a switch like the part # D16740 so that you can switch it off and on as needed. Basically you'd need to wire the switch inline with either the power or ground wire and you'd be set.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Work Light - Flood Beam - 780 Lumens - Flange Mount - Black Aluminum - Square - Qty 1
- Work Lights
- Flood Lights
- Work Lights
- Exterior Lights
- Square
- Recessed Mount
- Flood Beam
- LED Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Can Oil Cap RG04-230 be Used as Grease Cap
- Q&A: Trailer Hitch Recommendation for 2006 Subaru Forester
- Q&A: What are the Dimensions of the Replacement M6 Channel Nut for the Rhino-Rack Pioneer 6 Platform?
- Q&A: Determining Hanger Spacing for Replacement Leaf Springs on Trailer
- Article: Does Solar Panel Type Really Matter?
- Q&A: How to Pick Out Bearing for 10,000 lb Dexter Axle
- Q&A: Preventing Trailer Mounted Battery from Draining Battery on Tow Vehicle
- Q&A: Is Thinline Opti-Brite LED Interior Strip Light ILL72CB Good for Interior Cook Top Lighting
- Article: Trailer Wiring Diagrams
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Replace a Rubber RV Roof