2-1/2 Inch Diameter Red Round Trailer Clearance Light with Reflective Housing

Question

Question:

does this have reflectivity? # MC56RB?

asked by: Me

0

Expert Reply:

I do have a similar clearance light for you with a reflective housing but the Trailer Clearance or Side Marker Light part # MC56RB does not. Instead, you will want to take a look at the Trailer Clearance or Side Marker Light part # MCL59RB for LED or part # MC57RB incandescent. Unfortunately, these lights are only available with a recessed mount part # A55GB. You are also going to need to use the pigtail part # A46PB.

expert reply by: Conner L

0

Answer 1

The SAE AP2 98 on the lens indicates the lens rating but it isn't a part number. Light #MCL59RB is 2-1/2 inches in diameter and takes grommet #A55GB and harness #A46PB. But none of the clearance lights we have that are round and 2-1/2 inches have…

view full answer...

Answer 2

The red Optronics LED clearance light part #MCL59RB is 2-1/2 inches in diameter and designed to fit in grommets. For amber then you'd want the part #MCL59AB and you'd be set. These are very reliable and have reflectors built into them as…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Answer 10

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

2-1/2 Inch Diameter Red Round Trailer Clearance Light with Reflective Housing

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching