Spring Seat Recommendation for Dexter 5k Axle
Updated 09/25/2018 | Published 09/23/2018
Products Featured in This Question
Question:
10 K dexter axles are welded to mount springs under the axle. Is there any reason i couldnt mount under the springs. Thanks
asked by: Jeremy
Expert Reply:
Dexter axles like your 10k axles have a bow to them that "opens" down so that when a load is put on the trailer the axle is more or less totally flat. You can't flip the axles over as that would make the bow face the wrong direction and your wheel camber would be terrible. You can just install new spring seats on the side you need like you mentioned.
For a spring seat for a 5 inch axle like what you have you'd want the part # 3-66.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Looking for Pre-Greased 3,500 Idler Hub that is Galvanized for Trailer Axle
- Q&A: What Information Do You Need to Order a Correct Replacement Axle?
- Q&A: What Upgraded Equalizer Can I Use to Replace My 5 5/8" Long Standard Equalizer?
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Axle, Hubs, and Brakes for 2017 Jayco Jay Flight With Lippert Axle
- Article: How to Measure a Trailer Axle
- Q&A: What Are The Longest 3,500 lb Axle U-Bolts Available?
- Q&A: Does a Wheel's Width Matter When Buying a Tire?
- Q&A: Correct Replacement for Tru-Ryde Hub/Drum RVD-H-545
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs