Length of Replacement Drop Leg Pin # BD500338
Published 09/19/2018
Question:
What is distance for pin head to hole? What is total length of pin?
asked by: Jess
1
Helpful Expert Reply:
I measured the # BD500338 pin for you. It's total length is 4-7/8 inches and the usable length from the inside of the pin head to the hole is 2-3/4 inches.
expert reply by:
Charles S
1
click to enlarge
Product Page this Question was Asked From
Replacement Drop Leg Pull Pin w/Chain for Bulldog Trailer Jacks - 9/16" x 2-3/4" - Qty 1
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- 9/16 Inch Pull Pin
- Bulldog
more information >
Continue Researching
- Search Results: trailer jack pin
- Shop: Replacement Drop Leg Pull Pin w/Chain for Bulldog Trailer Jacks - 9/16" x 2-3/4" - Qty 1
- Shop: Linchpin Kit - 9/16" Diameter
- Q&A: Wiring Diagram for Wiring Switch to Landing Gear Motor of LG-142178
- Q&A: Replacing A Dometic Duo-Therm 59516.331 Condenser Unit With An Advent Air 15K BTU Replacement Unit
- Q&A: What is the Correct Brake Fluid to Use in Hydrastar Electric Over Hydraulic Brake Actuators
- Q&A: How To Measure a Boat Trailer Fender Without Removing the Wheel
- Q&A: How are the Steel and Diamond Plate Trailer Fenders Measured
- Q&A: What Size Wheel is On My 7.00-15 or 205/90D15 Tires?
- Q&A: Correct Hanger Spacing for the Tandem-Axle Trailer Hanger Kit Part # APT4
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: Determining Trailer Tongue Weight
- Article: Slipper Spring Trailer Suspension System Review
- Article: The 5 Best Trailer Drop Hitches You Can Buy