Troubelshooting No 12 Volt Power at Trailer Connector
Updated 09/15/2018 | Published 09/14/2018 >
Products Featured in This Question
Question:
hi i have 2012 amarok. the 7 pin plug doesnt seem to have acrive power to the aux point to work my 12v lights inside of my caravan. can you tell me why this is? do i need to wire it up or should it be active from factory?
asked by: David M
Expert Reply:
I can't say for sure if it's normal for the 12 volt pin to not be active on a 2012 Amarok since they aren't marketed in the US, but I can tell you that most vehicles with a factory 7-way have 12 volt power.
I'd start by checking the fuses. Look at your owner's manual to find which one it is.
If the fuse isn't the problem you can bypass the problem and just run 10 gauge wire using part # 10-1-1 from the 12 volt pin at the rear of your VW to its battery. You want to put a 40 amp circuit breaker, part # 9510, inline with it close to the truck's battery.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: What Size Wire And Circuit Breaker Should Be Used For The 12v Circuit On A 7-Way?
- Q&A: How to Add Electric Brakes to a 3,500 lb Lippert Idler Axle
- Q&A: Parts Needed to Add Brakes to Ranger Boat Trailer
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Upgrading From Electric Brakes on 16' Enclosed Trailer
- Q&A: Who Makes The Best Quality Trailer Bearings?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control


