Will 18" x 25" Generator Fit on the Stromberg Carlson Trailer Tray Cargo Carrier # CC-255

Question

Question:

The stromburg caralson will a generator 18x25 fit on platform

asked by: Ronald

0

Expert Reply:

It will be a close fit but your 18" x 25" generator will fit on the tray of the Stromberg Carlson Trailer Tray Cargo Carrier # CC-255.

If you look at the linked photo you can see that the very front of the tray measures 24-3/4" long, but since the tray is 20" wide you will have enough room.

expert reply by: Jon G

0

click to enlarge

Answer 1

The Mount-n-Lock GennyGo Generator and Cargo Carrier MNT34FR is meant to be mounted on the bumper of your RV and cannot be mounted to the tongue of your trailer without some pretty extreme modification and fabrication. However there is still a…

view full answer...

Answer 2

I don't think you'd have any issue removing your propane covers with the #CC-255 installed. If you check out the pictures I attached you'll see this installed on a trailer that has the white version of your cover installed. In the last…

view full answer...

Answer 3

Hey Michael. The 1976A736 schematic would be the one you would use to install the Soft Start Kit for Coleman-Mach RV Air Conditioners item #CM56RR. However, it's designed specifically for Coleman-Mach Series 45000, 47000, and 48000 air…

view full answer...

Answer 4

Hey Robert! The RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) is designed to replace the discontinued Atwood 31013. This has an adapter plate so it will mount in the same location and have a nice clean look. They also have a propane and…

view full answer...

Answer 5

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 6

Hey Matt, sounds like the Mount-n-Lock SafetyStruts Universal Bumper Brackets - 4" to 4-1/2" - Qty 2 #MO34VR will work on your setup. It's universal and attaches to just about any RV rear bumper. I've attached an installation video…

view full answer...

Answer 7

I have a great solution for you that will not require adding a hitch to the trailer so you won't have to move the spare tire and mount. Take a look at the Stromberg-Carlson cargo carrier #CC-255. It mounts at the front of an A-frame trailer frame…

view full answer...

Answer 8

I do have a possible solution for you but unfortunately there aren't any battery boxes available that will hold two 12V batteries and fit within a 21" length and 8" width. The closest thing we have is the TorkLift PowerArmor Locking…

view full answer...

Will 18" x 25" Generator Fit on the Stromberg Carlson Trailer Tray Cargo Carrier # CC-255

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching