Troubleshooting Edge Insight CS2 Comprehensive Gauge Display Not Powering Up
Published 09/07/2018
Question:
My Edge CTS2 Monitor wont power up when I hook up to the OBD port on my pick up. I know theres power there because my code reader turns on when I Hook up to it and my cigarette lighter works. I know the monitor works because I can plug it into a wall socket and go through the demo mode. Im super confused and need help. Thank you.
asked by: Tyler A
Expert Reply:
The issue with your Edge Insight CS2 Comprehensive Gauge Display # EP84030 not powering up is almost certainly a blown OBD-II fuse. You will need to consult the owner's manual of your pick-up to find out the type and location of that fuse and then replace it. That should remedy the issue and get your monitor up and running again.
Product Page this Question was Asked From
Edge Insight CS2 Comprehensive Gauge Display - Color Screen
- Performance Chip
- Monitors
- Color Screen
- Yes - California Approved
- Insight
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Best Air Bag Kit For 2026 Ram 3500 With In-Bed Hitch
- Article: Performance Chips and Modules
- Q&A: Parts Needed To Install 7-Way On a 2013 Chevrolet Express 2500 Passenger Van
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Anti-Rattle Devices
- Q&A: Trailer Hitch and Wiring for a 1997 Dodge B3500 Full Size Van
- Article: Rooftop Cargo Carriers
- Q&A: What Rear Anti-Sway Bar Fits a 2014 Chevy Silverado 2500 w/o a Factory Sway Bar?
- Article: How to Measure for Trailer Hitch Drop
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Is there a Gooseneck Hitch for a 2024 Ram 2500 w/out the Factory Prep Package?
- Q&A: Trailer Hitch Receiver for 2019 Toyota Tacoma With 2.7L Engine
- Q&A: Hitch and Wiring that Will use the Factory 7 and 4 Way Plug on the Bumper for 2019 Toyota Tacoma
- Article: 5 Things to Know About Weight Distribution Hitches