Is Drilling Required to Install Curt Trailer Hitch C11312 on a 2005 Ford Mustang
Updated 08/28/2018 | Published 08/27/2018
Products Featured in This Question
Question:
The description for this hitch says drilling is required but the install Instructions say drilling is not required. Can you please clear this up ??
asked by: Mike E
Expert Reply:
For Curt trailer hitch # C11312 for your 2005 Ford Mustang you might have to enlarge an access hole which you could do with a drill. But no new holes will need to be drilled. And you may not have to enlarge the access hole either.
If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you have to make sure the accessory is rated for use with a Class I trailer hitch. Also, with a bike rack, you are limited to 2 bikes maximum on a Class I hitch.
Curt also says you have to use stabilization strap # 18050 when using this hitch for any non-trailer load (such as a bike rack or cargo carrier) per their warranty requirements. I have linked the Class I compatible 2-bike racks and cargo carriers for you.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Parts Needed To Flat Tow 2025 Ford Ranger
- Q&A: Can a Trailer Hitch be Installed on a 2007 Ford Mustang GT
- Q&A: Does Curt Hitch C11312 Fit 2008 Ford Mustang GT
- Q&A: How Many Threaded Ports on Demco Solenoid Kit DM5404
- Q&A: How Does The Demco Reverse Lockout Solenoid Kit DM5404 Install?
- Q&A: Installation of Trailer Brake Controller in 2000 Chevy Express 3500 Van
- Q&A: Recommended Flagpole Holder for 1-1/4 Trailer Hitch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)