Troubleshooting Bowed Inno Roof Rack on a 2015 Ford Fusion
Updated 07/25/2018 | Published 07/24/2018
Products Featured in This Question
Question:
I have the INNO square bars inb137, INSU feet, INK860. 2015 ford fusion. I spaced the front stays at 21 1/2 and rear at 21 3/8 according to the directions. The bars are bowing. Are the stays too far apart or did i tighten them down too much??
asked by: Scott O
Expert Reply:
It looks like you have the spacing correct for the Inno Roof Rack # INB137, # INSUT, and # INK860 on your 2015 Ford Fusion, but I would just double check that the feet are not binding and that the base carrier has been installed correctly. You may also need to adjust your towers (if that can be done) to help get your square bars to sit level.
Product Page this Question was Asked From
Custom Fit Kit for Inno XS200, XS250, and INSU-K5 Roof Rack Feet
- Accessories and Parts
- Roof Rack
- Fit Kit
- 4 Pack
- Inno
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Inno Square Crossbars - Steel - Black - 58" Long - Qty 2
- Shop: Roof Rack
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller Installation: Starting from Scratch