What is Included with Trailer Hitch # C11356 for a 2016 Mazda 6

Published 07/21/2018

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(146)

$203.59

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(31)

$74.11

1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs

(361)

$35.57

2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs

(361)

$40.41

Curt Class II Drawbar - 5" Rise - 9-5/8" Long - 3,500 lbs

(2327)

$31.89

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 9-3/8" Long - 3,500 lbs

(2327)

$42.88

Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2" Span

(2977)

$4.13

Question:

I was looking at the 5inch draw bar but nto sure which one i need? What size is the standard draw bar? Also does the ball come included?

asked by: Bernardo C

Helpful Expert Reply:

The recommended ball mount for Curt trailer hitch receiver, part # C11356, is 9-3/8 inches long with 2-5/8 inches of rise or 3-1/4 inches of drop. It's part # C45016.

If you prefer a draw bar with 5 inches of rise use part # C45014. The hitch ball is not included so you can use part # A-82 for a 2 inch ball or part # A-80 for a 1-7/8 inch. They'll fit both the included and the other draw bar I mentioned and # F-4 is the pin and clip that fits.

You also need a wiring harness to power the trailer's lights. Use part # 118587 which installs by plugging in behind both tail lights inside your trunk. Then there's a wire that needs to be run to the vehicle's battery through the included fuse.