Size of Drain to Use with Lippert Components Shower Pan # LC210377

Question

Question:

54x28 shower pan drain hole what siZe does not accomodate 2 inch pipe

asked by: Albert

1

Helpful Expert Reply:

The standard RV shower drain for use with the Lippert Components Shower Pan # LC210377 that you referenced is the # A01-2012VP which has a 2-1/2 inch steel flange and fits 1-3/4 inch drain holes and 1-1/2 inch P-traps.

expert reply by: Jameson C

1

Answer 1

I believe we have exactly what you're looking for. I went out to the warehouse and personally measured the LaSalle Bristol P-Trap Fitting for RV Sewer System #344633211N and measured 3-1/2" from the middle of the fitting to the first bend in…

view full answer...

Answer 2

Put the pin back in and wind it 12-16 times rolling it towards the camper to put the correct tension in the slide topper #LCV000163285 before installing it. This will give you the correct amount of tension for extending and retracting the awning.

view full answer...

Answer 3

Without knowing what slide topper you have, I cannot say with 100% certainty what assembly you need. The odds are good that you have a Solera slide topper and the correct option for the right side would be the Replacement Right-Side Head and Roll Bar…

view full answer...

Answer 4

I have a solution for you, but my contact over at Lippert tells me that you won't be able to replace just those casings on Solera Slide-Out Topper. The parts you need are the Replacement Idler Head and Roll Tube for Solera RV Slide-Out Awning -…

view full answer...

Answer 5

The Replacement Mounting Hardware part #LC701665 comes with the Extension Rods, Extension Rod Bracket, Torsion Arm Caps, and various hardware. I am not sure what all you have now but it sounds like you might also need the torsion heads, part #LC87FR…

view full answer...

Answer 6

There are many Heavy Duty/Super Duty 1 ton trucks that can tow 20,000 lb 5th wheel campers cross country. I recommend getting a long bed truck and getting the factory prep package so you will have a clean bed for other uses when not towing. If you do…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Size of Drain to Use with Lippert Components Shower Pan # LC210377

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching