Replacement Coupler Recommendation for Damaged A-Frame Coupler
Updated 07/17/2018 | Published 07/16/2018
Question:
i need to replace the bolt and the wedge on attached drawing. I have not been able to reference the part or kit I would need. Please see attached drawing. Thank You
asked by: Arnold
0
Expert Reply:
I really wish we had the specific part you circled in the picture you submitted but that's not something we carry. Our best solution would be to replace the A-Frame coupler with something like the A-Frame Coupler part # CA-5210-B that you referenced.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
A-Frame Trailer Coupler - Yoke Latch - Black - 2" Ball - Weld On - 8,000 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Weld-On
- 8000 lbs GTW
- 2 Inch Ball Coupler
- Yoke Latch
- 2-1/4 Inch Hole
- Standard Grade
- etrailer
more information >
Continue Researching
- Q&A: Is There A Replacement Latch Kit Or Coupler For Older Atwood Coupler 88555 Flip Latch ?
- Q&A: Replacing the Drop Leg Spring Loaded Pull Pin on a Bulldog 180 Series Square Jack
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Q&A: Looking For Brake Assemblies And Hubs For Dexter 4,400 lb EZ-Lube Axles
- Q&A: Solution for A-Frame Trailer Coupler Yoke Latch Repair Kit
- Q&A: How To Find Correct Replacement Electric Braking Assembly Parts for a Trailer
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Article: Most Popular Wheel Bearings
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Lighting Requirements
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)